Aerial Bracket
Mount an aerial without making holes?
Range Rover Sport, Discovery 3 & 4
Aerial Bracket
Mount a light or medium weight aerial on either or both sides of a Range Rover Sport, Discovery 3 or 4 using existing bolts.
Made with 3mm Marine Grade Stainless Steel.
Mount a light or medium weight aerial on either or both sides of a Range Rover Sport, Discovery 3 or 4 using existing bonnet bolts.
Made with 3mm Marine Grade Stainless Steel.
Open the bonnet, locate and remove the forward upper hinge bolt on the selected side. Fit the bracket so that the top face of the tongue is touching the bottom edge of the bonnet and tighten the bolt. Mount the aerial and run the coax cable following the windscreen washer hose and electrical wiring layout as it is on the left hand side.
On the driver’s side (of right hand drive vehicles) there is a hole through the double skin firewall to run cables through. Remove the large cover at the rear and look in at the firewall next to the steering linkage. You will see a black rubber grommet, up high, on the firewall just to the side of the steering linkage.
Remove the grommet and punch a hole through the centre large enough to fit the cable(s) through snugly. Push a scribe into the centre of the hole in the firewall and through the second hole behind that (double firewall) into the carpet. Remove the driver’s side under dash panel and look up to see the point of the scribe. Cut an X with a sharp knife using the scribe as the centre. You can now push your cable(s) through to the inside.
Click Aerial Bracket to BUY NOW!
Go to Product Catalogue